Solved Problem on Bridge Circuits

Q. A strain gauge forms one arm of the bridge shown in the figure below and has a nominal resistance without any load as R_s = 300 ohm . Other bridge resistances are R₁ = R₂= R₃ = 300 ohm . The maximum permissible current through the strain gauge is 20 mA. During certain measurement when the bridge is excited by maximum permissible voltage and the strain gauge resistance is increased by1% over the nominal value, the output voltage V0 in mV is

Options: (A) 56.02 (B) 40.83 (C) 29.85 (D) 10.02

Ans: C

Log in or register to post comments
119 views

Comments

Solved Problem on Strength of Materials

A rod of length L having uniform cross-sectional area A is subjected to a tensile force P as shown in the figure below. If the Young’s modulus of the material varies linearly from E1 to E2 along the length of the rod, the normal stress developed at the section-SS is

Solved Problem on DC Motors

The separately excited dc motor in the figure below has a rated armature current of 20 A and a rated armature voltage of 150 V. An ideal chopper switching at 5 kHz is used to control the armature voltage ...

Solved Problem on OP-AMPS

In the circuit shown below the op-amps are ideal. Then determine the value of Vout in Volts.

Solved Problem on OP-AMPS

In the circuit shown below what is the output voltage (Vout) in Volts if a silicon transistor Q and an ideal op-amp are used?

GATE Syllabus for Chemical Engineering (CH)

Graduate Aptitude Test in Engineering, 2013. Syllabus for Chemical Engineering (CH). ENGINEERING MATHEMATICS:- Linear Algebra: Matrix algebra, Systems of linear equations, Eigen values and eigenvectors etc . CHEMICAL ENGINEERING Process Calculations and Thermodynamics etc