Solved Problem on Bridge Circuits

Submitted by tushar pramanick on Tue, 07/23/2013 - 01:52
Share icon

Q. A strain gauge forms one arm of the bridge shown in the figure below and has a nominal resistance without any load as Rs = 300 ohm . Other bridge resistances are R1 = R2 = R3 = 300 ohm . The maximum permissible current through the strain gauge is 20 mA. During certain measurement when the bridge is excited by maximum permissible voltage and the strain gauge resistance is increased by1% over the nominal value, the output voltage V0 in mV is

 

Options: (A) 56.02 (B) 40.83 (C) 29.85 (D) 10.02

 

Ans: C

Tags

Comments

Related Items

Solved Problem on Riveted joints

A single riveted lap joint of two similar plates as shown in the figure below has the following geometrical and material details. width of the plate w = 200 mm, thickness of the plate t = 5 mm, number of rivets n = 3, diameter of the rivet dr = 10 mm ...

Solved Problem on hinged Joints

A hinged gate of length 5 m, inclined at 30° with the horizontal and with water mass on its left, is shown in the figure below. Density of water is 1000 kg/m3...

Solved Problem on Gear Trains

A compound gear train with gears P, Q, R and S has number of teeth 20, 40, 15 and 20, respectively. Gears Q and R are mounted on the same shaft as shown in the figure below. The diameter of the gear Q is twice that of the gear R..

Solved Problem on Heat Transfer

Consider one-dimensional steady state heat conduction, without heat generation, in a plane wall; with boundary conditions as shown in the figure below. The conductivity of the wall is given by k = k0 + bT ..

Solved Problem on Sliding Contact Bearings

Q. A link OB is rotating with a constant angular velocity of 2 rad/s in counter clockwise direction and a block is sliding radially outward on it with an uniform velocity of 0.75 m/s with respect to the rod..