Solved Problem on Foundation Engineering

Submitted by tushar pramanick on Tue, 07/23/2013 - 18:25

Linked Answer Questions
Statement for Linked Answer Questions Q1 and Q2:
A multistory building with a basement is to be constructed. The top 4 m consists of loose silt, below which dense sand layer is present up to a great depth. Ground water table is at the surface. The foundation consists of the basement slab of 6 m width which will rest on the top of dense sand as shown in the figure. For dense sand, saturated unit weight = 20kN/m3, and bearing capacity factors Nq = 40 and Nγ = 45. For loose silt, saturated unit weight = 18kN/m3, Nq = 15 and   Nγ = 20.Effective cohesion c' is zero for both soils.Unit weight of water is 10 kN/m3. Neglect shape factor and depth factor.
Average elastic modulus E and Poisson’s ratio μ of dense sand is 60 x 103kN/m2 and 0.3 respectively.

 

 

Q1. Using factor of safety = 3, the net safe bearing capacity (in kN/m2) of the foundation is:

 

(A) 610 (B) 320 (C) 983 (D) 693

 

 

Q2. The foundation slab is subjected to vertical downward stresses equal to net safe bearing capacity derived in the above question. Using influence factor If = 2.0, and neglecting embedment depth and rigidity corrections, the immediate settlement of the dense sand layer will be:

 

(A) 58 mm (B) 111 mm (C) 126 mm (D) 179 mm

 

 

 

Comments

Related Items

Solved Problem on Bridge Circuits

A strain gauge forms one arm of the bridge shown in the figure below and has a nominal resistance without any load as Rs = 300 ohm . Other bridge resistances are R1 = R2 = R3 = 300 ohm ...

Solved Problem on DC Motors

The separately excited dc motor in the figure below has a rated armature current of 20 A and a rated armature voltage of 150 V. An ideal chopper switching at 5 kHz is used to control the armature voltage ...

Solved Problem on OP-AMPS

In the circuit shown below the op-amps are ideal. Then determine the value of Vout in Volts.

Solved Problem on OP-AMPS

In the circuit shown below what is the output voltage (Vout) in Volts if a silicon transistor Q and an ideal op-amp are used?

GATE Syllabus for Chemical Engineering (CH)

Graduate Aptitude Test in Engineering, 2013. Syllabus for Chemical Engineering (CH). ENGINEERING MATHEMATICS:- Linear Algebra: Matrix algebra, Systems of linear equations, Eigen values and eigenvectors etc . CHEMICAL ENGINEERING Process Calculations and Thermodynamics etc